ARP Oil Pump Drive Shaft, Chromoly (Up to 1996 Small Block Chevy)
SKU: ARP-134-7901
MPN: 134-7901
Ships directly from the manufacturer; please allow an additional 2-5 days for delivery
$17.53
Guide to shipping notes:
- No Free Shipping: No free shipping options available if an order contains this item
- No Expedited Shipping: No expedited shipping options available if an order contains this item
- No Free/Expedited Shipping: No free or expedited shipping options available if an order contains this item
- Hazard Fee: Hazardous material shipping fee is applied to the shipping rate if an order contains this item; no free or expedited shipping options available
- Pickup Only: No shipping options available if an order contains this item; pickup only
- Pickup/Local/LTL Only: Pickup only if an order contains this item, or reach out to us for local delivery or LTL options
Details
Details
Many an engine has been destroyed as a result of oil pump driveshaft failure. To cure this all-too-common problem, ARP has designed an extra heavy-duty shaft that will provide you with the necessary reliability. The shaft is made from heat-treated, premium grade aerospace chrome moly steel. Moreover, the shaft diameter is a larger diameter than the OEM unit. These features combine to enable ARP shafts to handle the added torque requirements of increased capacity oil pumps or heavy viscosity lubricants.
IMPORTANT NOTE: Make sure you ALWAYS check clearances: shaft to block and pump to distributor.
CHEVY DRIVES: Made from premium grade 8740 and heat-treated to 190,000 psi, ARP uses a unique manufacturing process where the alignment sleeve is roll formed onto the shaft (not welded or pinned), enabling the sleeve to float, allowing for slight misalignment.
FORD DRIVES: Made from ARP2000 and heat-treated to 220,000 psi. These pump drives feature a CNC milled (not broached) hex, and has the retaining washer installed.
IMPORTANT NOTE: Make sure you ALWAYS check clearances: shaft to block and pump to distributor.
CHEVY DRIVES: Made from premium grade 8740 and heat-treated to 190,000 psi, ARP uses a unique manufacturing process where the alignment sleeve is roll formed onto the shaft (not welded or pinned), enabling the sleeve to float, allowing for slight misalignment.
FORD DRIVES: Made from ARP2000 and heat-treated to 220,000 psi. These pump drives feature a CNC milled (not broached) hex, and has the retaining washer installed.